Sable V6-183 3.0L DOHC VIN S MFI (1997)
^
Connect ring type terminal end ground wire to location shown in Figure 8.
^
Reconnect yellow wire to pump sending unit harness.
24.
Clean fuel pump-to-gas tank mating surface.
25.
Install new seal onto fuel pump-to-gas tank mating surface.
26.
Install fuel pump. Align marks made during disassembly. Tighten lock-ring to 44 Nm (33 lb/ft).
27.
Position fuel tank under vehicle.
28.
Raise fuel tank enough to connect front EVAP hose.
29.
Connect front EVAP hose.
30.
Raise fuel tank enough to connect fuel lines.
31.
Connect fuel supply and return lines.
32.
Connect fuel pump electrical connector.
33.
Raise fuel tank to installed position.
34.
Install fuel tank strap retaining bolts. Tighten bolts to 46-63 Nm (33-46 lb/ft).
