Recall: Campaign - Fuel Gauge/Sender Assembly
WARNING
DO NOT OPERATE ENGINE OR SMOKE WHILE REFUELING.
Expedition
1.
Install memory saver, then disconnect battery negative cable.
2.
Remove fuel system pressure as follows:
^
Remove schrader valve cap and attach EFI/CFI fuel pressure gauge.
^
Slowly open manual valve on fuel pressure gauge to relieve fuel system pressure.
3.
Raise and support vehicle.
4.
Completely drain fuel tank. It may be necessary to disconnect fuel filler hose to drain fuel tank.
5.
Disconnect fuel filler and vent hoses from fuel tank. Refer to Figure 1.
6.
Disconnect rear EVAP hose from top of fuel tank. See Figure 1.
7.
Support fuel tank with adjustable jack.
8.
Remove fuel tank straps retaining bolts. The skid plate, fuel tank and straps will be removed as an assembly.
9.
Slightly lower fuel tank.
