Sable V6-183 3.0L DOHC VIN S MFI (1997)
Main Relay (Computer/Fuel System): Description and Operation
PURPOSE
The Constant Control Relay Module (CCRM) interfaces with the Powertrain Control Module (PCM) to provide control of the cooling fan, A/C
clutch, and fuel pump. The module includes the Electronic Engine Control (EEC) power relay to provide power to the PCM.
These relays are contained in one housing, resulting in longer service life and reduced wiring requirements for operation.
CONSTRUCTION
The CCRM has one 24-pin connector. Relays contained in the housing are independent of one another.
OPERATION
The relays contained within the CCRM are interdependent and work with each other. The following describes the different relay functions within
the CCRM:
EEC Power Relay
For any other circuit in the CCRM to operate, this circuit must be powered up. This prevents actuators from being turned on without the EEC
system having control over them.
Fuel Pump Relay
The fuel pump relay circuit controls the fuel pump. The PCM provides the ground circuit for the primary side of the relay. The secondary side
supplies Battery Voltage (B+) to the fuel pump itself.
Low Fan Control Relay
The Low Fan Control (LFC) relay controls the electric cooling fan. The primary control circuit of the LFC relay is normally high (B+). In this
state the low speed cooling fan runs continuously. The PCM grounds this circuit, pulling it low near zero volts, to turn the fan off. This "fail
safe" is built into the fan control circuit to run the fan anytime the EEC power relay is activated if the PCM should fail open circuit.
High Fan Control Relay
The High Fan Control (HFC) circuit operates the high speed electric cooling fan. If the Engine Coolant Temperature (ECT) sensor relays a
high temperature or overheat condition to the PCM, it activates the HFC. In order to turn the high speed cooling fan on, the PCM grounds the
primary circuit of the HFC relay. The secondary circuit applies B+ to the cooling fan motor.
Wide Open Throttle A/C Control Relay
This circuit controls the A/C compressor clutch during normal operation. This circuit also disengages the A/C clutch as commanded by the
PCM during Wide Open Throttle (WOT) conditions. This solid state relay has two control circuits. One is used to engage the A/C clutch upon
demand from the vehicle operator and the A/C cycling pressure switch. The other control is used to disengage the clutch upon command from
the PCM.
Power Ground
This circuit provides the CCRM with a ground source for operating various controls. The circuit uses one pin that goes to the battery negative
terminal.
