Sable V6-183 3.0L DOHC VIN S MFI (1997)
Shift Indicator: Adjustments
1. Remove steering column tilt release lever (if equipped) by turning counterclockwise.
2. Remove ignition lock cylinder.
3. Remove upper and lower steering column shrouds.
4. Place transaxle range selector lever in OD (OVERDRIVE) position or D (DRIVE) position on vehicles equipped with a Transmission Control
Switch (TCS). A weight of 1.4 kg (3 lbs) should be hung on the transaxle range selector lever to make sure the lever is located firmly on the OD
(OVERDRIVE) or D (DRIVE) position on vehicles equipped with a TCS detent.
5. Loosen transmission range indicator cable retaining screw.
6. Adjust transmission range indicator cable (with adjustment wheel on transmission range indicator cable), until transmission range indicator pointer
is centered on or D (DRIVE) position on vehicles equipped with a TCS and calibration dots show no red.
7. Tighten transmission range cable retaining screw to 3 Nm (26 in lb).
8. Cycle transaxle range selector lever through all of the positions and check that the transmission range indicator pointer is centered over proper
letter or number in each range position.
9. Install steering column shrouds with retaining screws.
10. Install ignition lock cylinder.
11. Install tilt release lever, if equipped.
