Sable V6-183 3.0L DOHC VIN S MFI (1997)
Air Bag: Service and Repair
Removal and Installation
Driver's Side
NOTE: If the driver side air bag module did not deploy in a collision, it may not have been needed. Complete all diagnostics before replacing the driver
side air bag module.
WARNING: The electrical circuit necessary for system deployment is powered directly from the battery. To avoid accidental deployment and
possible personal injury, the negative battery cable must be disconnected prior to servicing or replacing any system components.
REMOVAL
1. Record pre-set radio frequencies for reprogramming following completion of service procedures.
2. Disconnect battery ground cable.
3. Wait one minute for back-up power supply energy to be depleted.
4. Remove two steering wheel spoke covers from steering wheel.
5. Remove two screw and washer assemblies retaining driver side air bag module to steering wheel.
6. Disconnect the air bag electrical connector from air bag sliding contact connector. Remove driver side air bag module.
WARNING: Place air bag module on bench with trim cover facing up.
INSTALLATION
1. Connect air bag electrical connector to air bag sliding contact connector.
2. Position driver side air bag module to steering wheel and secure with two screw and washer assemblies tightened to 10.2-13.8 Nm (91-122 lb in).
3. Install two steering wheel spoke covers.
