Sable V6-183 3.0L DOHC VIN S MFI (1997)
Side Air Bag: Service and Repair
Passenger Side Air Bag
NOTE: If the passenger side air bag module did not deploy in a collision, it may not have been needed. Complete all diagnostics before replacing the
passenger side air bag module.
WARNING: The electrical circuit necessary for system deployment is powered directly from the battery. To avoid accidental deployment and
possible personal injury, the negative battery cable must be disconnected prior to servicing or replacing any system components.
REMOVAL
1. Record pre-set radio frequencies for reprogramming following completion of service procedures.
2. Disconnect battery ground cable.
3. Wait one minute for back-up power supply energy to be depleted.
4. Remove passenger side air bag module trim cover from instrument panel.
NOTE: The passenger side air bag module trim cover is retained by snap-in tabs.
5. Open glove compartment, press sides inward and lower glove compartment to floor.
6. Through glove compartment opening, remove two passenger air bag module retaining screws.
7. Disconnect two electrical connectors and remove passenger side air bag module.
WARNING: Place air bag module on bench with trim cover facing up to avoid possible personal injury.
INSTALLATION
NOTE: Fill out and return air bag traceability postcard for new air bag with VIN numbers and note diagnostic trouble code.
1. Connect two electrical connectors to passenger side air bag module and position passenger side air bag module in instrument panel.
2. Install two module retaining screws. Tighten to 7.6-10.4 Nm (68-92 lb in).
3. Return glove compartment to correct position.
4. Install passenger side air bag trim cover by snapping into place on the instrument panel.
5. Reconnect battery ground cable.
6. Prove out air bag system.
