Sable V6-183 3.0L DOHC VIN S MFI (1997)
9. Remove seat belt anchor bolt and retractor and tongue from rear deck panel.
INSTALLATION
1. To install, reverse removal procedure.
2. Make sure the safety belt webbing is not twisted. If it is, remove the twist.
3. Tighten retractor anchor bolt and safety belt anchor plate-to-sill bolt to 34-46 Nm (25-33 lb ft).
4. Check the restraint system for proper operation.
Second Row
REMOVAL
1.Remove rear seat cushion.
NOTE: If auxiliary seat safety belts are present, they must be detached from rear seat safety bolts at the C-pillar.
2. Remove rear seat back.
3. Hold stud stationary at the hex collar that is located behind the quarter trim panel and remove quarter trim panel.
4. Remove bolt and D-ring assembly from C-pillar post.
5. Remove rear seat safety belt anchor plate-to-sill bolt.
6. Remove rear seat safety belt anchor bolt and safety belt retractor and tongue from C-pillar.
7. Remove seat belt webbing from quarter trim panel and roof side inner moulding.
INSTALLATION