Sable V6-183 3.0L DOHC VIN S MFI (1997)
Crankshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control
Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 10 miles or more to relearn the strategy.
2. Raise vehicle on a hoist.
3. Remove splash shield from RH front fender apron.
4. Disconnect the engine control sensor wiring from the Crankshaft Position (CKP) sensor.
5. Remove CKP sensor retaining bolt and remove sensor.
INSTALLATION
1. Make sure sensor mounting surface is clean. Make sure that the CKP sensor O-ring is in proper location on the sensor.
2. Position CKP sensor and install retaining bolt. Tighten bolt to 8-12 Nm (71-106 lb in).
CAUTION: Do not overtighten CKP sensor retaining bolt or damage to the sensor may occur.
3. Properly route engine control sensor wiring and connect electrical connector to crankshaft position sensor.
4. Install splash shield. Tighten retaining screws securely.
5. Lower vehicle.
6. Connect battery ground cable.
