Sable V6-183 3.0L DOHC VIN S MFI (1997)
Steering Column Cover: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Turn ignition switch lock cylinder to RUN position.
3. Place a 3.17 mm (1/8-inch) diameter wire pin or small drift punch in hole in lower steering column shroud under ignition switch. Press retaining
pin while pulling out on ignition switch lock cylinder to remove it from steering column lock cylinder housing.
4. Remove lower instrument panel steering column cover.
5. Remove the upper steering column shroud and lower steering column shroud by removing the four self-tapping screws.
INSTALLATION
Follow removal procedure in reverse order.
