Sable V6-183 3.0L DOHC VIN S MFI (1997)
Wheel Fastener: Service and Repair
Wheel Fastener
Anti-Theft
CAUTION:
^
Make sure the key is held square to the lug nut. If the key is on an angle, it may damage the key and the anti-theft lug nut. DO NOT use a power
impact wrench on the wheel hub bolt nut key.
^
DO NOT use a power impact wrench on the lug nut key.
Remove or install the anti-theft lug nut as follows:
1. Insert the key into the slot of the lug nut.
2. Place the wheel lug nut wrench on the key.
3. While applying pressure on the key, remove or install the lug nut.
4. The key has a circular keyway that is matched to the female slot in the anti-theft lug nut. When locking wheels are reinstalled, tighten to
115-142 Nm (85-104 ft. lbs.).
Regular
CAUTION Failure to tighten lug nuts in a star pattern may result in high rotor runout, which will speed up the development of brake toughness, shudder
and vibration.
^
Install lug nuts using Rotunda Accutorq(r) Lug Nut Sockets 164-R0303 or equivalent on a 1/2-inch drive impact wrench or torque wrench.
^
Tighten to 115-142 Nm (85-104 ft. lbs.).
