Sable V6-183 3.0L DOHC VIN S MFI (1997)
7. Install four new seals on accumulator pistons. Lubricate seals with a light coating of petroleum jelly.
8. Install four accumulator pistons into their bores.
CAUTION: Do not allow pistons to cock in their bores; seal or bore damage may result.
9. Install four accumulator piston shafts.
NOTE: Use petroleum jelly to keep shafts in place during chain cover installation; shafts can be installed after chain cover is installed.
10. Install manual valve detent spring. Tighten retaining bolt to 9-12 Nm (80-106 inch lbs.).