Sable V6-183 3.0L DOHC VIN S MFI (1997)
Using a clean wool applicator, apply primer to inside glass edge 21 mm (0.8 inch) wide along top and sides and 70 mm (2.75 inch) wide
along bottom.
9.
NOTE: Leave a door window slightly open until adhesive is cured.
NOTE: Apply new urethane on top of existing material on pinch weld.
Apply an even bead of Urethane Adhesive WSB-M2G316-B or equivalent around entire sheet metal pinch weld next to windshield moulding
retaining leg. The bead should be triangular in shape, 16 mm (0.625 inch) high and 8 mm (0.33 inch) at base. Apply a double bead of
urethane along the cowl top and the bottom of windshield opening.
10.
Install windshield glass onto vehicle, taking care to align marks on windshield glass to marks on body. This must be done before adhesive
skins over.
11.
Remove spacer and install headliner, windshield wiper arms, blades, visors and interior garnish moulding.
12.
Install inside rear view mirror.
13.
CAUTION: Use only urethane for service of air and water leaks in urethane set windshield.
CAUTION: When replacing urethane installed glass parts, do not drive the vehicle until the urethane has cured. At temperatures above 13°C
(55°F) and relative humidities above 50%, adequate cure time is typically 12 to 24 hours (less at higher temperatures and lower humidities). See
detailed instructions provided by the urethane manufacturer. Inadequate or improper curing can adversely affect the retention of the windshield.
Check installation for air and water leaks in urethane seal.
