Sable V6-183 3.0L VIN U FI (1998)
Power Steering Pressure Switch: Service and Repair
REMOVAL
1. Open hood.
2. Disconnect battery ground cable.
3. Disconnect electrical connector at Power Steering Pressure Switch (PSP switch).
4. Remove power steering pressure switch from power steering auxiliary actuator.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Replace O-ring on power steering pressure switch. Tighten power steering pressure switch to 7 - 14 Nm (62 - 123 inch lbs.).
3. Fill and bleed power steering system with Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid XT-2-QDX or equivalent meeting Ford
MERCON specification. Check system for leaks and proper operation.