Sable V6-183 3.0L VIN U FI (1998)
5. Turn rear planet support over. Remove No. 16 final drive gear thrust race (select fit) from rear planet support.
6. Using air nozzle, apply 40 psi of regulated air to low intermediate apply port to remove piston and seal assembly. Service as required.
WARNING: ALWAYS WEAR SAFETY GLASSES WHEN USING COMPRESSED AIR TO AVOID PERSONAL INJURY.
NOTE: Seal is part of piston and is serviced as an assembly.
7. Use Collet D801-100-L and Actuator Pin D801-100-F (from Blind Hole Puller Set D80L-100-A) or equivalents and Impact Slide Hammer
T50T-100-A to remove two rear lube oil transfer tube seals).
CAUTION: Use care not to damage any machined surfaces.
