Sable V6-3.0L VIN U (1999)
2. Disconnect rear brake anti-lock sensor from the mating body connector located under the vehicle in the center on No. 4 crossmember as shown.
3. Disconnect routing clips from rear suspension arm and bushing and No. 4 crossmember torque box.
4. On station wagon, remove retaining bolt and rear brake anti-lock sensor from rear disc brake adapter on sedan and from rear wheel spindle.
Installation
1. Insert rear brake anti-lock sensor into hole in rear disc brake adapter on sedan, and into hole in rear wheel spindle on station wagon. Install
retaining bolt. Tighten to 7.6 - 10.4 Nm (68 - 92 inch lbs.).
2. Install sensor routing clips to rear suspension arm and bushing and No. 4 crossmember torque box.
3. Connect rear brake anti-lock sensor to mating body connector as shown.
4. Lower vehicle.
