Sable AWD V6-3.5L (2008)
Passenger seat and driver seat with manual lumbar
19. Remove the tie strap.
Seat with manual lumbar
20. Remove the 2 screws and separate the lumbar adjuster.
21. Release the lumbar basket at the bottom and top and remove the assembly.
Passenger seat
22. Separate the backrest latch cable pin-type retainer at the lower left corner of the backrest frame.
23. Remove the 4 bolts and remove the backrest latch assembly and cable.
Assembly
Passenger seat
1. Position the backrest latch with cable and install the 4 bolts.
-
Tighten to 25 Nm (18 lb-ft).
2. Attach the backrest latch cable pin-type retainer at the lower left corner.
Seat with manual lumbar
3. Attach the lumbar basket to the backrest frame at the bottom and top.
4. Position the lumbar adjuster and install the 2 screws.
Passenger seat and driver seat with manual lumbar
5. Wrap the 3 tie straps around the backrest latch cable and lumbar cable at the top and sides of the seat backrest frame.
All seats
6. WARNING:
-
Inspect the seat side air bag module cavity in the seat backrest foam pad for any foreign material. If any foreign material is found,
remove it. Failure to follow these instructions may result in the seat side air bag module deploying incorrectly and increases the risk of
serious personal injury or death in a crash.
-
Before installing the seat side air bag module/deployment chute assembly:
-
Inspect the side air bag module and mounting surfaces for any damage or foreign material.
-
Remove any foreign material from the mounting surfaces of the deployment chute, the seat backrest frame mounting bracket and
the air bag module cavity in the seat backrest foam pad.
-
Install new parts if damaged.
Failure to follow these instructions may result in the seat side air bag deploying incorrectly, which increases the risk of serious
