Sable AWD V6-3.5L (2008)
3. Remove the 2 screws on each side at the bottom of the load floor panel.
4. Pull out to release the retainers and remove the load floor panel.
-
Use a suitable tool (pin-type retainer tool, etc.) to disengage the load floor from the seat.
5. Remove the screw, release the tab and remove the floor latch cover.
-
For bench seats, remove 2 floor latch covers.
6. CAUTION: Use care when separating the seat back trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn
from the seat back foam.
NOTE: Bench seat shown, 50/50 seat similar.
Release the cushion trim cover retainers from the cushion frame and remove the cushion trim cover.
-
On assembly, the LATCH and child safety seat tether anchor must be accessible through the trim cover.
7. To install, reverse the removal procedure.