Sable AWD V6-3.5L (2008)
Thermostat Housing: Service and Repair
Thermostat Housing
Material
Removal and Installation
1. Drain the cooling system.
2. Remove the air cleaner outlet pipe.
3. Disconnect the 5 coolant hoses from the thermostat housing and position them aside.
4. Remove the 3 thermostat housing bolts.
^
To install, tighten to 10 Nm (89 lb-in).
5. NOTE: Do not pull the other end of the coolant tube out of the engine block when separating the thermostat housing.