Sable AWD V6-3.5L (2008)
![background image](/mercury/sable_awd/v6-3.5l/Page-604002.png)
3. Remove the crankshaft sensor ring.
4. NOTE: Install the engine stand bolts into the cylinder block only. Do not install the bolts into the oil pan.
Mount the engine on a suitable engine stand.
5. If equipped, remove the heat shield and disconnect the block heater electrical connector.
^
Detach all of the engine block heater harness retainers and remove the harness.
6. If equipped, disconnect the heated PCV electrical connector.