Sable AWD V6-3.5L (2008)
Knock Sensor: Service and Repair
KNOCK SENSOR (KS)
Removal and Installation
1. Remove the thermostat housing.
2. Remove the lower intake manifold.
3. Remove the coolant tube.
-
Discard the O-ring seal.
4. Disconnect the knock sensor (KS) electrical connector.
5. Remove the 2 bolts and the KS.
-
To install, tighten to 20 Nm (15 lb-ft).
6. To install, reverse the removal procedure.
-
Lubricate the new O-ring seal with clean engine coolant.