Topaz L4-140 2.3L CFI (1985)
![background image](/mercury/topaz/l4-140_2.3l_cfi/Page-1266005.png)
^
Remove the air induction tube (flex tube) completely.
^
Locate the tamper resistant cap and remove it.
2.
Retract the ISC Motor and adjust the Hardstop Idle Setting.
-
In the engine compartment, find the self-test connector and self-test input (STI) connector.
-
Connect a jumper wire between self-test input connector and signal return pin on the self-test connector.
HARDSTOP (THROTTLE STOP ADJUSTING SCREW) RPM SETTING PROCEDURE (CONT.)
^
Turn the ignition key to "RUN" position. DO NOT START THE ENGINE.
^
The ISC plunger will retract in 5-15 seconds.
^
Disconnect the ISC motor from the wire harness.
^
Return the ignition key to the "OFF" posftion.
^
Then remove the jumper wire.
^
Turn the engine "ON".
^
Warm up the engine to Normal Operating Temperature for 2-3 minutes.