Topaz L4-140 2.3L CFI (1985)
-
Connect a jumper wire between self-test input connector and signal return pin on the self-test connector.
HARDSTOP (THROTTLE STOP ADJUSTING SCREW) RPM SETTING PROCEDURE (CONT.)
^
Turn the ignition key to "RUN" position. DO NOT START THE ENGINE.
^
The ISC plunger will retract in 5-15 seconds.
^
Disconnect the ISC motor from the wire harness.
^
Return the ignition key to the "OFF" posftion.
^
Then remove the jumper wire.
^
Turn the engine "ON".
^
Warm up the engine to Normal Operating Temperature for 2-3 minutes.
^
Turn all accessories off, check the hardstop RPM (cooling fan off) in Neutral (MTX) or Drive (ATX) for proper RPMs and TV linkage adjustment
(ATX), see chart.
^
If TV linkage, on automatic transmission equipped vehicles, is out of adjustment, adjust using the following procedure before adjusting Hard
Stop-Idle.
-
Loosen the bolt on the sliding trunnion block, on the TV control rod assembly, one turn minimum.