Topaz V6-182 3.0L (1992)
9.
Using a 9/32 inch drill bit, drill two (2) holes at locations marked in step 7.
CAUTION:
Dry fill all connectors. Do not use any conductive lubricant.
10.
Reconnect female connector to vehicle wire harness. Using the two (2) push pin retainers provided, attach the jumper harness connector to the fan
shroud at the holes drilled. See Figure 2.
11.
Connect battery negative cable, then remove memory saver.
12.
Check cooling fan motor for proper operation.
13.
Close hood.
Affected Vehicles:
1992-1994 Lincoln Continental Equipped with 3.8L Engine
Required Parts:
F43Z-14K095-DA
Installation Procedure
1.
Open hood.
2.
Install memory saver, then disconnect battery negative cable.
3.
Remove the sight shield from above the radiator and engine cooling fan area.
4.
Disconnect existing vehicle wiring harness connector from cooling fan motor harness.
5.
Disengage cooling fan motor wire harness retainers from their locations on the shroud.
6.
Reposition and secure cooling fan motor harness to mounting pad located on fan shroud to the right of the original location using existing retainer.
See Figure 3.