Topaz V6-182 3.0L (1992)
Fig. 18 Evaporator Case Cover Removal
Fig. 19 Evaporator Core Removal
13.
Remove two screws attaching support bracket and brace to cowl top panel, Fig. 15.
14.
Remove air inlet duct from evaporator case (four screws).
15.
Remove foam seal from evaporator core tubes.
16.
Drill a 3/16 inch hole in both upright tabs on top of evaporator case, Fig. 16.
17.
Using a small saw blade, cut the top of evaporator case between two raised outlines, Figs. 17 and 18.
18.
Remove two blower motor resistor retaining screws, then blower motor resistor.
19.
Fold cutout cover back from case, Fig. 19.
20.
Remove evaporator core.
21.
Reverse procedure to install, noting the following:
a. Install caulking cord (rope sealer) part No. D9AZ-19560-A or equivalent to seal evaporator case against leakage along cut line.
b. Install a spring nut on each of the two upright tabs and with the two holes drilled in the front flange. Ensure hole in spring nut is aligned with
the 3/16 inch holes drilled in the tab and flange. Install and tighten screw in each spring nut (through the hole in the tab or flange) to secure the
cutout cover in the closed position.
c. On models equipped with airbag, rearm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM
DISARMING.