mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

A/C System - Intermittent Cooling|Page 5017 > < A/C System - Intermittent Cooling|Page 5011
Page 1
background image

Refrigerant Pressure Sensor / Switch: Customer Interest
A/C System - Intermittent Cooling

Article No. 
92-9-5

04/22/92

AIR CONDITIONING - INTERMITTENT LOSS OF COOLING - VEHICLES BUILT BEFORE 1/22/92

FORD:
1992 TEMPO

LINCOLN-MERCURY: 
1992 TOPAZ

ISSUE:
Intermittent A/C cooling may be caused by the lack of continuity in the A/C clutch cycling pressure switch. This can result in an inoperative A/C system.
This condition may be caused by corrosion in the switch assembly as a result of water wicking down the wires and through the connector attached to the
clutch cycling pressure switch.

ACTION:
Install a new clutch cycling pressure switch and apply butyl sealer. Refer to the following procedure for service details.

1.

Test the clutch cycling pressure switch for continuity.

2.

If the switch does not have continuity, install a new switch (E35Y-19E561-A).

3.

Use a small flat brush to apply butyl sealer (C9AZ-19554-B) to the top of the wiring harness connector at the point where the wires enter, Figure 1.

PART NUMBER

PART NAME

CLASS

E35Y-19E561-A

A/C Clutch Cycling Pressure

AM

Switch

C9AZ-19554-B

Butyl Sealer

AM

OTHER APPLICABLE ARTICLES:
NONE
WARRANTY STATUS:
Eligible Under Bumper To Bumper Warranty Coverage
OPERATION DESCRIPTION

TIME

920905A

Replace Cycling Switch And

0.5 Hr.

A/C System - Intermittent Cooling|Page 5017 > < A/C System - Intermittent Cooling|Page 5011