Topaz V6-182 30L (1992) Instrument Cluster Air Bag Arming and Disarming Service Repair
Air Bag(s) Arming and Disarming: Service and Repair
Arming and Disarming
To Deactivate System:
1. Disconnect battery positive cable. Wait one minute. This is the time required for backup power supply in diagnostic monitor to deplete its stored
energy.
2. Remove four nut and washer assemblies retaining driver air bag to steering wheel.
3. Disconnect driver air bag connector.
4. Attach Rotunda air bag Simulator 105-00008 or equivalent on clockspring to simulate the air bag.
5. Connect battery positive cable.
To Reactivate System:
1. Disconnect battery positive cable.
2. Remove Rotunda Air Bag Simulator Tool from air bag terminals on clockspring assembly, if connected.
3. Reconnect driver air bag module connector.
4. Position driver air bag module on steering wheel and secure with four nut and washer assemblies (10 mm). Tighten nut and washer assemblies to
4-5.6 Nm (36-49 lb-in).
5. Connect battery positive cable.
6. Verify air bag indicator.