Topaz V6-182 3.0L (1992)
Removal and Installation
1. Remove plug button at shoulder belt retainer anchor cover
2. Disconnect shoulder belt anchor at retainer.
3. Remove emergency release lever handles.
NOTE: Relieve pressure of retaining clip on underside of handles, while gently pulling handles off.
4. Remove console retaining screws.
5. Remove armrest, if so equipped.
6. Disengage shoulder harness opening bezel from the console.
7. Remove the retractor.
8. To install, reverse Removal procedure. Tighten retractor to floor brace retaining bolts to 30-40 Nm (23-29 lb-ft).
2-Door
Removal
1. Remove A-pillar and B-pillar garnish mouldings.
2. Remove rear seat.
3. Cycle shoulder belt retainer full forward.
4. Disconnect electrical switch connectors at A- and B-pillars.
5. Remove plug button from shoulder belt anchor cover.
6. Remove Torx(R) head screw retaining shoulder belt anchor to shoulder belt retainer and disconnect shoulder belt anchor.
7. Remove two screws retaining drive belt track to motor.
8. Remove one screw, adjacent to motor, retaining vertical drive belt guide.
9. Carefully disconnect drive belt track from motor, allowing belt to pass by gear teeth without engagement.
10. Remove screw from A-pillar bracket to A-pillar.
11. Remove two bolts retaining track assembly to B-pillar.
12. Remove two screws retaining track assembly to inner roof rail.
13. Remove screws from overhead track retaining clips.
14. Disengage vertical guide release tab at B-pillar bracket.
15. Rotate track inboard to remove track limit switch retaining tab from slot in A-pillar.
16. Slide drive belt out of vertical guide.