Topaz V6-182 3.0L (1992)
Impact Sensor: Service and Repair
Front Center Sensor
Removal
NOTE: To service stripped front outboard sensor retaining screws, replace screws with 6 mm self-tapping screws. Tighten to 2.7-3.7 Nm (24-32
lb-in).
1. Disconnect positive battery cable.
2. Remove air induction resonator.
3. Disconnect center front sensor electrical connector.
4. Remove three screws retaining center front sensor to radiator support. Remove sensor from vehicle.
Installation
1. Position front center sensor with arrow on top pointing toward front of vehicle and secure to radiator support with three retaining screws. lighten
screws to 10.2-13.8 Nm (91-122 lb-in).
2. Connect front center sensor wire lead connector to wiring assembly connector.
3. Install air induction resonator.
4. Connect positive battery cable.
5. Verify air bag indicator.