Topaz V6-182 3.0L (1992)
3.
Clean and reseal the complete transaxle using Seal Kit (E8FZ-7153-A). Be sure to pay particular attention when installing the three (3) new teflon
seals on the pump support, Figure 3, and the two (2) new teflon seals on the intermediate clutch hub, Figure 4. Verify that the teflon seals are
lapped correctly. See Figures 3 and 4.
4.
Reassemble transaxle. Refer to the Service Manual, Section 07-01. Use Valve Body Guide Pins T80L-77100-A, to maintain proper gasket
orientation during final assembly.
5.
Install the overhauled or replacement transaxle in the vehicle.
a.
Set the shift cable adjustment and TV linkage adjustment.
b.
Check the transaxle fluid level.
NOTE:
REFER TO SERVICE LABOR TIME STANDARDS MANUALS FOR LABOR OPERATIONS REQUIRED TO REPLACE OR OVERHAUL
THE TRANSAXLE.
OTHER APPLICABLE ARTICLES: 94-4-7
SUPERSEDES: 94-7-11
WARRANTY STATUS:
Eligible Under The Provisions Of The Bumper To Bumper Warranty Coverage For 1992/93 Models, Eligible Under Basic And Powertrain Warranty
For All Other Models
OPERATION DESCRIPTION
TIME
941211A
R&I Main Control Assy., R&I
1.6 Hrs.
Governor Assy., Check Shift
Cables And TV Linkage
DEALER CODING
BASIC PART NO.
CONDITION CODE
7A100
63
OASIS CODES: 501000