Topaz FWD L4-140 2.3L HSC (VIN X) (1989)
/Page-1493001.png)
Air Bag(s) Arming and Disarming: Service and Repair
TO DEACTIVATE SYSTEM:
1. Disconnect battery ground cable.
2. Remove four nut and washer assemblies securing driver air bag to steering wheel.
3. Disconnect driver air bag connector.
4. Attach jumper wire to air bag terminals on clockspring.
5. Connect battery ground cable.
TO REACTIVATE SYSTEM:
1. Disconnect battery ground cable.
2. Remove jumper wire from air bag terminals on clockspring assembly, if connected.
3. Reconnect driver air bag module connector.
4. Position driver air bag module on steering wheel and secure with four 10 mm nut and washer assemblies. Tighten to 4-6 Nm (35-53 lb-in).
5. Connect battery ground cable.
6. Verify air bag lamp.
