Tracer L4-110 1.8L DOHC (1995)
Speedometer Drive Gear And Bearing Cone Installation
1. Install speedometer drive gear and bearing cone (speedometer drive gear end) using driver handle tool No. T80T-4000-W, or equivalent, and a
press, and differential bearing cone replacement tool No. T88C-77000-EH, or equivalent.
2. Install bearing cone (ring gear end) using driver handle tool No. T80T-4000-W and differential bearing cone replacer tool No. T88C-77000-EH,
or equivalents.
3. Install thrust washers and pinions.
4. Install pinion shaft and lock pin, then crimp lock pin so it may not be removed.
5. Install thrust washers and side gears.