Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
g.
Disconnect this connector and replace the antenna with the revised Antenna (F7XZ-18812-BB).
4.
To remove the antenna lead wire perform the following steps:
a.
Remove the center air register.
b.
Remove the ash tray.
c.
Remove the center instrument panel (finish panel).
d.
Remove and disconnect the HVAC control head.
e.
Remove the two (2) screws from the center air duct and position it out of the way to access the wire clip at the I/P support (Figure 4).
f.
Route wire and secure wire clip to I/P support.
g.
Replace the wire Antenna Lead Wire (F7XZ-18812-AB) and secure the wire clip to the I/P support.
5.
To install, reverse Steps 4a-4g.
