Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Power Seat Switch: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
2. Slide the front seat lap belt through the front seat cushion side shield.
3. Remove the front seat cushion side shield screws and remove the front seat cushion side shield.
4. Remove the two seat back control switch and housing screws.
5. Disconnect the seat back control switch and housing electrical connector.
6. Remove the seat control switch.
7. Slide the seat back control switch off of the housing.
INSTALLATION
1. To install, reverse the removal procedure.