Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Vacuum Brake Booster Check Valve: Service and Repair
REMOVAL
1. Disconnect the brake booster hose (intake manifold side) from the power brake booster check valve. Discard the hose clamp.
2. Disconnect the vacuum hose (brake booster side) from the power brake booster check valve. Discard the hose clamp.
3. Remove the power brake booster check valve from the clip located on the bulkhead.
INSTALLATION
Power Brake Booster Check Valve
NOTE: Install the power brake booster check valve in the proper direction as indicated by the engine directional arrow on the power brake booster
check valve.
1. To install, reverse the removal procedure.
^
Install using new hose clamps.