Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Rear Brake Anti-Lock Sensor Electrical Connector
6. Disconnect the rear brake anti-lock sensor electrical connector.
7. Slide the rear brake anti-lock sensor from its retaining clips and remove the rear brake anti-lock sensor from the vehicle.
INSTALLATION
1. Position the rear brake anti-lock sensor on the vehicle in the retaining clips.
2. Connect the rear brake anti-lock sensor electrical connector.
3. Position the brake anti-lock sensor cable-to-body bracket on the vehicle. Install the brake anti-lock sensor cable-to-body bracket bolt. Tighten the
brake anti-lock sensor cable-to-body bracket bolt to 10 Nm (88 inch lbs.).
4. Position the rear brake anti-lock sensor cable-to-rear axle housing bracket on the rear axle housing. Install the brake anti-lock sensor cable-to-rear
axle housing bracket bolt. Tighten the brake anti-lock sensor cable-to-rear axle housing bracket bolt to 10 Nm 88 inch lbs.).
5. Position the rear brake anti-lock sensor on the brake backing plate. install the brake anti-lock sensor bolt. Tighten the brake anti-lock sensor bolt to
11-15 Nm (124-133 inch lbs.).
CAUTION: Do not force the rear brake anti-lock sensor into the mounting hole.
6. Lower the vehicle.