Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
f.
Adjust the tension of the drive belt by tightening the generator adjustment bolt.
g. Tighten the generator locking bolt to 16-20 Nm (12-15 ft. lbs.).
h. Tighten the inner and outer generator-to-bracket bolts to 22-27 Nm (16-20 ft. lbs.).
i.
Install the RH engine and transmission splash shield.
j.
Lower the vehicle.
Deflection Adjustment
1. Apply 98 N (22 Lbs) of pressure to the generator drive belt at a point midway between the generator pulley and the crankshaft pulley.
NOTE: If the drive belt has been in service for some time, it should be inspected before adjustment. A drive belt that is severely glazed, frayed,
cracked, or contaminated with oil must be replaced. Minor cracks in the back of the drive belt are acceptable as long as no large pieces are
missing.
2. The drive belt deflection should measure 6.5-7.5 mm (0.256-0.295 inch) for a new drive belt or 7.5-8.5 mm (0.295-0.335 inch) for a used drive
belt. The limit of deflection is 12 mm (0.47 inch).
NOTE: Always check the drive belt deflection when the engine is cold, or has been stopped for at least 30 minutes. A drive belt is considered
new if it has been used on a running engine for less than five minutes.
3. If the drive belt deflection is not as specified, adjust the generator drive belt tension.
