Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Blower Motor: Service and Repair
Auxiliary Blower Motor
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the center seat(s).
3. Remove the rear air conditioning and heating assembly access panel from the LH quarter trim panel. Use an appropriate trim tool and pry off the
access panel from the top.
4. Disconnect the heater blower motor electrical connector.
5. Remove the three blower motor screws and remove the blower motor from the rear air conditioning and heating assembly.
6. To remove the blower motor wheel, squeeze the blower motor wheel retainer and separate the blower motor and blower motor wheel.
INSTALLATION
1. To install, reverse the removal procedure.