Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Blower Motor Switch: Service and Repair
Auxiliary A/C-Heater System
REMOVAL
1. Disconnect the battery ground cable.
2. Use an appropriate trim tool to pry the rear climate control assembly from the LH quarter trim panel.
3. Disconnect the blower motor switch electrical connector.
4. Remove the two blower motor switch screws.
5. Remove the rear blower motor control knob.
6. Remove the blower motor switch from the rear climate control assembly.
INSTALLATION
1. To install, reverse the removal procedure.