Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Knock Sensor: Service and Repair
REMOVAL
1. Remove the lower intake manifold.
2. Remove the coolant crossover tube. See: Engine, Cooling and Exhaust/Cooling System/Coolant Line/Hose/Service and Repair
3. Disconnect the battery ground cable.
4. Disconnect the Knock Sensor (KS) electrical connector.
5. Remove the KS bolt and the KS from the cylinder block.
INSTALLATION
To install, reverse the removal procedure.
-
Tighten the KS bolt to 25-34 N.m (18-25 lb-ft).
