Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Stabilizer Link: Service and Repair
Rear
REMOVAL
1. Raise and support the vehicle.
2. Hold the rear stabilizer bar link and bushing stud with a wrench and remove the lower rear stabilizer bar link and bushing nuts. Remove the rear
stabilizer bar from the rear stabilizer bar link and bushing.
3. Remove the two upper rear stabilizer bar link and bushing bolts.
4. Remove the rear stabilizer bar link and bushing and the rear stabilizer bar link and bushing bracket assembly from the vehicle.
INSTALLATION
1. To install, reverse the removal procedure.
^
Tighten the two upper rear stabilizer bar link and bushing bolts to 16-22 Nm (12- 16 ft. lbs.).
^
Tighten the lower rear stabilizer bar link and bushing nut to 39-45 Nm (29-33 ft. lbs.).