Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
3.
Remove the outer plate and the two (2) upper outer rubber bushings.
4.
Tip the inner plate with the two (2) upper bolts and rubber bushings downward toward the center of the vehicle while working the assembly
outward.
Installation (Left Side)
NOTE:
THE TWO (2) REAR SPRING FRONT MOUNTING PLATES ARE MARKED INNER AND OUTER. BE SURE THE REAR SPRING FRONT
MOUNTING PLATES ARE INSTALLED ON THE CORRECT SIDE.
1.
Replace the two (2) upper rear spring front mounting plates with new plates and bolts.
2.
Reverse the removal procedure to install. Replace the lockwashers and nut on both upper bolts.
3.
Install the rear spring front bolt, lockwasher, and nut.
4.
Torque all three (3) nuts to 58-75 N.m (43-55 lb-ft).
