Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
1. Use a hydraulic press and Step Plate Adapter D80L-630-5 or equivalent, to press the output shaft rear bearing onto the output shaft.
2. Use a brass drift to press the output shaft bearing into the output shaft bearing retainer.
3. Install the bearing outer snap ring onto the bearing retainer.
4. Install the new lubrication circuit seal rings onto the output shaft. Wrap the output shaft to prevent the lubrication circuit seal rings from
expanding.
CAUTION: The output shaft lubrication circuit seal rings must be replaced.
NOTE: Pack the output shaft and output shaft bearing retainer lubrication circuit seal ring grooves with petroleum jelly.
5. Install new lubrication circuit seal rings onto the output shaft bearing retainer. Wrap the output shaft bearing retainer with paper and tape to
prevent the lubrication circuit seal rings from expanding.