Villager V6-201 3.3L SOHC VIN T SFI (1999)
Keyless Entry Transmitter: Service and Repair
PROGRAMMING
NOTE: Each electronic door lock control system operates on its own Transmitter Identification Code (TIC). If additional transmitter(s) are required or
replaced, each new TIC must be programmed into the Smart Entry Control (SEC)/timer module. The SEC/timer module will accept up to four keyless
entry remote transmitters.
Each TIC can be programmed into the SEC/timer module by completing the following procedure:
1. While inside the vehicle, close and lock all the doors.
2. Insert and remove the key from the ignition at least 6 times within 10 seconds to enter the programming mode. The parking lamps will flash to
indicate that the programming mode has been entered.
3. Turn the key to the accessory position. All four previous codes will now be erased.
4. Press any button on the remote transmitter once. The parking lamps will flash twice to acknowledge acceptance.
5. To enter additional remote transmitter(s), unlock and then lock the driver side door using the master window/door lock/unlock switch.
6. Press any button on the additional transmitter(s). The parking lamps will flash twice to acknowledge acceptance.
7. Open the driver door to exit the programming mode; the parking lamps will flash twice to confirm exiting the mode.