Villager V6-201 3.3L SOHC VIN T SFI (1999)
![background image](/mercury/villager/v6-201_3.3l_sohc_vin_t_sfi/Page-2024001.png)
Lock Cylinder Switch: Service and Repair
Liftgate Lock Cylinder Disarm Switch
REMOVAL
1. Remove the liftgate trim panel.
2. Position the watershield aside.
3. Remove the liftgate lock cylinder disarm switch.
1
Remove the "E" clip.
2
Remove the lock rod actuator.
3
Remove the liftgate lock cylinder disarm switch.
^
Disconnect the electrical connector.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE:
^
The liftgate lock cylinder disarm switch locator mark must be positioned towards the harness side of the switch prior to installation.
^
The liftgate lock cylinder disarm switch must be installed in its original position.