Villager V6-201 3.3L SOHC VIN T SFI (1999)
Hood Latch Release: Service and Repair
REMOVAL
1. Remove the hood latch.
2. If equipped, remove the mud flap.
3. Remove the splash shield.
1
Remove the screws.
2
Remove the pin-type retainers.
3
Remove the splash shield.
4. Release the hood release cable locators in the inner fender opening.
5. Remove the LH scuff plate.
6. Remove the LH A-pillar lower trim panel.
7. Remove the hood release handle and cable assembly.
1
Remove the bolts.
2
Remove the hood release handle and cable assembly.
-
Release the rubber grommet from the cowl side panel.
INSTALLATION
1. Position the hood release handle and cable.
-
Thread the hood release cable through the cowl panel opening and engage the locators in the inner fender.