Villager V6-201 3.3L SOHC VIN T SFI (1999)
Engine Block Heater: Service and Repair
Removal
1. Drain the cooling system.
2. Raise and support the vehicle.
3. Disconnect the block heater electrical connector.
4. CAUTION: Do not remove the block heater screw.
Remove the block heater.
1. Loosen the screw.
2. Turn the block heater and remove.
Installation
1. CAUTION: Do not use any type of silicone lubricant or sealer on the O-ring.
CAUTION: Make sure the block heater harness is secure and away from exhaust system components.
NOTE: Make sure that the heater element is pointing down in the installed position.
NOTE: Lubricate the O-ring with the provided lubricant.
To install, reverse the removal procedure.