Villager V6-201 3.3L SOHC VIN T SFI (1999)
Turn Signal Switch: Service and Repair
MULTIFUNCTION SWITCH
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the steering column upper and lower shroud.
^
Remove the four screws.
3. Remove the multifunction switch.
1
Remove the screws.
2
Disconnect the electrical connectors.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive
strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.