Villager V6-201 3.3L SOHC VIN T SFI (1999)
Multiplex Communication Network: Flow of Diagnosis
1. Verify the customer concern by operating the system in question.
2. Visually inspect for obvious signs of electrical damage.
VISUAL INSPECTION CHART
Electrical
^
Central Junction Box (CJB) Fuses F37 (10 A), F54 (10 A)
^
Battery Junction Box (BJB) Fuses F6 (10 A)
^
Wiring harness
^
Loose or corroded connections
^
Anti-lock brake control module
^
Air bag diagnostic monitor
^
Transmission control Module (TCM)
^
Powertrain Control Module (PCM)
3. If the concern remains after the inspection, connect New Generation STAR (NGS) Tester to the Data Link Connector (DLC) located beneath the
instrument panel and select the vehicle to be tested from the NGS Tester menu. If NGS Tester does not communicate with the vehicle:
^
check that the program card is properly installed.
^
check that the correct version of the program card is installed.
^
check the connections to the vehicle.
^
check that you are connected to diagnostic connector C252 for all module diagnostics.
^
check that you are connected to DLC C2018 for OBDII diagnostics and power for the NGS Tester.
^
check the ignition switch position.
If NGS Tester still does not communicate with the vehicle, go to Pinpoint Test E. See: Pinpoint Tests/E: No Communication - No Power to NGS
Through DLC C2018
4. Go to Pinpoint Test PC. See: Initial Inspection and Diagnostic Overview/System Precheck