Villager V6-201 3.3L SOHC VIN T SFI (1999)
Transmission Position Switch/Sensor: Service and Repair
Special Tools
Removal
1. Position the shifter in the NEUTRAL (N) position.
2. Disconnect the battery ground cable.
3. Raise and support the vehicle.
4. Remove the engine splash shield.
5. Remove the transmission range (TR) sensor.
1
Remove the shifter cable nut.
2
Disconnect the TR sensor electrical connector.
3
Remove the screws.
4
Remove the TR sensor.
Installation
1. NOTE: The lever on the TR sensor must align with the manual shift linkage rod.
NOTE: The special tool passes through the manual shift linkage rod, the TR sensor lever, and into the TR sensor.
Install the TR.
1
Position the TR sensor.
2
Loosely install the bolts.
3
Install the special tool.