Villager V6-201 3.3L SOHC VIN T SFI (1999)
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the upper and lower steering column shroud,
^
Remove the steering column shroud screws.
3. Remove the ignition lock bolts by grooving the heads of the break-away bolts with a hammer and chisel.
4. Remove the key-in-reminder switch.
^
Remove the two screws.
5. Remove the ignition switch lock cylinder.
^
Place a 3 mm (1/8 inch) diameter wire pin or small drift in the access hole in the lock housing under the ignition switch lock cylinder. Depress
the retaining pin while pulling on the ignition switch lock cylinder.